How To Install A Front Camera On Your Phone

Introduction

Employ this guide to replace the front-facing camera in your Samsung Galaxy S4.

Pry with a plastic opening tool, or your fingernail, in the divot to the left of the rear-facing camera, near the power button.

Pry with a plastic opening tool, or your fingernail, in the divot to the left of the rear-facing camera, most the power push button.

Lift the rear case by the corner nearest the divot and remove it from the phone.

Lift the rear case by the corner nearest the divot and remove it from the phone.

Utilise the flat end of a spudger, or your fingernail, to press the microSD carte slightly deeper into its slot until yous hear a click.
Afterward the click, release the menu and it will pop out of its slot.
Remove the microSD card.
For reassembly, push the microSD card into the slot until it clicks in place.

Insert a plastic opening tool, or your finger, into the notch of the battery compartment and lift the battery upward.
Remove the battery from your phone.

Use a plastic opening tool, or your fingernail, to press the SIM carte slightly deeper into its slot until y'all hear a click.
After the click, release the card and it will pop out of its slot.
Remove the SIM bill of fare.
During reassembly, push the SIM bill of fare into the slot until information technology clicks in place.

Remove the nine 4.0 mm Phillips #00 screws securing the midframe to the brandish associates.

The midframe is secured to the brandish assembly by several plastic clips behind the chrome bezel of the midframe. The side by side few steps will guide you lot through separating the clips to free the midframe.
Starting on the volume button side of the telephone, insert your plastic opening tool between the chrome bezel around the brandish glass and the larger chrome border slice. Look for the seam betwixt the two.
Slide the opening tool along the seam, separating the plastic clips as you lot go.
Be very gentle whilst prying, and pry only enough to split up the plastic clips—there are several thin points in the midframe bezel that may cleft if you bend them too much.

Continue prying around the corner of the phone.
Slide your opening tool along the seam between the midframe and display along the bottom of the device, releasing more of the plastic clips.

Proceed sliding the opening tool effectually the top of the phone, releasing the last of the clips and freeing the midframe from the display assembly.
At this indicate, you may desire to run your plastic opening tool along the entire perimeter of the device again, to brand certain you've released all of the plastic clips.